Beginner's Guide to Buying a Kneeboard
article is aimed at the novice Kneeboarder as it is assumed that
an intermediate or advanced rider will probably know most of this
Kneeboards are made from 2 main materials - rotomolded plastic or composite material (like a wakeboard). Rotomolded kneeboards are perfect for recreational / family use as they offer fantastic value for money and are extremely robust. Composite kneeboards offer higher performance but are more expensive and fragile. If you are new to kneeboarding or are looking for a family board then a rotomolded board will be perfect for you.
Recreational / beginner kneeboards often have what is known as a Hydro Hook (a.k.a. Aquatic Hook). This is a simple plastic flip-up hook (or plastic block) attached to the nose of the board to enable the tow handle to be attached to it and take all the load during deep water starts. The handle is simply placed behind the hook, which then takes all of the load off the rider when the tow vehicle powers up. Once up to speed and composed, the rider can then pull the handle toward them, which detatches it and gives them full control.
Rocker is the measure
of how much a Kneeboard curves from nose to tail (kneeboards are
somewhat banana shaped when viewed side-on). The higher the number
the greater the curvature. Recreational boards are designed with
quite a lot of rocker as this makes them slower in the water,
more forgiving, and more relaxed in the turns. They also provide
softer landings if/when you get "air". Intermediate
and advanced boards have less rocker and are therefore faster
in the water and in the turns, but landings will be harsher as
Beginner / recreational
kneeboards have soft rounded edges whereas intermediate to advanced
boards have quite sharp ones. Rounded edges make the board less
agressive in the turns and are better for beginners as you are
less likely to "catch an edge" and take a tumble.
Fins provide forward stability and tracking and give the kneeboard "grip" on the water. Without fins a kneeboard will still travel in a reasonably straight line as it is longer than it is wide, but it will be able to rotate freely and very loosely on the surface of the water which requires skill to control. In addition to straight line tracking, fins also enable the rider to load up the line and accelerate on the approach to the boat wake. They then provide grip and stability on the landing. Kneeboard fins are normally moulded into the board along with moulded channels for additional stability and grip. The nearer the edge the fins are the more effect they have and the bigger and wider they are the more drag they create and therefore the more stability they provide. Beginner kneeboards therefore tend to have larger wider fins and advanced boards have smaller thinner fins (or none at all). Some kneeboards also have retractable fins so that beginners can get the benefit of the stability they provide but more advanced riders can retract them and obtain the more desirable "loose" feel necessary for performing tricks etc.
We hope you found this article useful but if you have a question that is not covered here or you just need some advice then please do get in touch and one of our friendly and knowledgeable staff will gladly assist you.